Compaq 380 Specifiche Scaricare il pdf (Pagina 68)

2-56 Compaq ProLiant DL380 Generation 2 Server Maintenance and Service Guide

Rear Fan Bracket

To remove the rear fan bracket:

1. Power down the server. See the “Powering Down the Server” section in this chapter.

2. Extend or remove the server from the rack. See the “Preparation Procedures” section in

this chapter.

3. Remove the access panel. See the “Access Panel” section in this chapter.

4. Remove the PCI riser cage. See the “PCI Riser Cage” section in this chapter.

5. Remove the air baffle. See the “Air Baffle” section in this chapter.

6. Remove all hot-plug fans. See the “Hot-Plug Fan” section in this chapter.

7. Remove the front fan bracket. See the “Front Fan Bracket” section in this chapter.

8. Remove the system board. See the “System Board” section in this chapter.

NOTE: When removing the system board, you may leave the DIMMs, the processors, the PPMs, the

Smart Array 5i Controller, and the system battery on the system board, unless you are replacing them as

failed items.

9. Use a Torx T-15 screwdriver to remove the screws that secure the rear fan bracket to the

system board

10. Rotate the rear fan bracket toward the edge of the system board and remove the bracket .

Figure 2-55. Removing the rear fan bracket

Reverse steps 1 through 10 to replace the rear fan bracket.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 120 121

Nessun commento

Compaq 380 Specifiche Pagina 68